Grand Caravan V6-3.3L VIN R (2005)
-
Power Door Locks
-
Automatic Door Lock
-
Door Lock Inhibit
-
Central Locking (with VTSS Only)
-
Battery Protection
-
The BCM will automatically turn off all exterior lamps after 3 minutes and all interior lamps after 15 minutes after the ignition is turned off, if
they are not turned off by the driver.
-
Chime Driver
-
Compass/Minitrip Support
-
Interior Lighting (Courtesy/Reading Lamps)
-
BCM Diagnostic Reporting
-
Electronic Liftgate Release (with Power Door Locks)
-
Exterior Lighting
-
Headlamp Time Delay (with/without Auto headlamps)
-
Automatic Headlamps (with electrochromatic mirror)
-
Illuminated Entry
-
Fade to Off
This feature dims the interior lighting (courtesy lamps) gradually if the BCM does not receive any new inputs that would cause the interior lamps to
remain on.
-
PWM Instrument Panel Dimming
-
Door Lock Inhibit
This feature disables the door lock functions if the key is in the ignition and either front door is ajar. Pressing the RKE lock/unlock button under these
conditions, result in normal lock/unlock activation.
-
Power Sliding Door Switch Inputs
The BCM has 4 switch inputs for the power sliding door feature: Located in the overhead console are the Left and Right side sliding door switches to
activate either or both sliding doors under the proper conditions. Also there are B-Pillar switches located on the Left and Right B-pillar posts.
-
Power Liftgate Switch Input
The BCM has 1 Liftgate switch input located in the overhead console
-
Power Lockout Switch Input
The BCM has 1 Lockout switch that when enabled will disable the B-Pillar sliding door switches from activating either sliding door when depressed.
When replacing a body control module there are 2 modules available, a Base and a Midline. The Midline controller is used on vehicles that have Power
Door Locks. If a vehicle is equipped with the Vehicle Theft Security System, the midline controller becomes a premium when the theft feature is
enabled.
NOTE: Do not swap the body control module between vehicles or body control modules off the shelf.
Engineering does not recommend that service, dealers or the plant swap Body Control Modules (BCM) between vehicles or off the shelf. The BCM has
internal diagnostic capability that assists in diagnosing the system. When an 'open' or a 'Short' circuit exists, the diagnostic tool can be used to read the
BCM codes. The codes are very descriptive in identifying the appropriate feature that has faulted. The BCM also learns what features are on the vehicle
and if modules are swapped the BCM could set false DTC's based on what it learned.
Chime Warning System
The BCM monitors the door/liftgate ajar switches, multifunction switches, headlight switch, ignition switch, PCI bus, and the diagnostic tool to perform
various chime operations. The BCM uses a low-side driver to control the chime located in the cluster.
The chime system provides the Driver with warning chimes for:
-
Seat belt
-
Exterior lights on
-
Key-in Ignition
-
Key-in Accessory
-
Engine temperature critical
-
Low washer fluid
-
Turn signals on
-
Dome light on
-
Low oil pressure
-
Any warning lamp announcement
-
High-speed warning Gulf Coast Countries (GCC) only
The output sound intensity of the chime is approximately 72 decibels.
CHIME PRIORITY