Grand Caravan V6-3.3L VIN R (2005)
Idle Speed/Throttle Actuator - Electronic: Service and Repair
REMOVAL
When servicing throttle body components, always reassemble components with new 0-rings and seals where applicable. If assembly of component is
difficult, a light coat of engine oil may be applied to the 0-RINGS ONLY to aid assembly. Use care when removing hoses to prevent damage to hose or
hose nipple.
1. Disconnect negative cable from battery.
Idle Air Control Valve Location
2. Remove electrical connector from idle air control valve.
3. Remove idle air control motor mounting screws.
4. Remove motor from throttle body. Ensure the O-rings is removed with the valve.
INSTALLATION
O - Rings
When servicing throttle body components, always reassemble components with new O-rings and seals where applicable. Never use lubricants on O-rings
or seals, damage may result. If assembly of component is difficult, a light coat of engine oil may be applied to the O-RINGS ONLY to aid assembly. Use
care when removing hoses to prevent damage to hose or hose nipple.
1. Carefully place idle air control motor into throttle body.
2. Install mounting screw. Tighten screws to 7 N.m (62 in. lbs.) torque.
3. Connect electrical connector to idle air control motor.
4. Connect negative cable to battery.
