dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Engine Controls - Warm Engine Rough Idle|Page 5024 > < Engine Controls/Ignition - MIL ON/Misfire DTC's Set|Page 5019
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - Warm Engine Rough Idle

NUMBER: 18-016-04

GROUP: Vehicle Performance

DATE: April 13, 2004

THE SOFTWARE WILL BE AVAILABLE ON TechCONNECT APRIL 13, 2004.

SUBJECT:
Flash: Rough Idle When Engine Is At Normal Operating Temperature

OVERVIEW:
This bulletin involves selectively erasing and reprogramming the Powertrain Control Module (PCM) with new software.

MODELS:

2004 - 2005

(RG)

Chrysler Voyager

2004 - 2005

(RS)

Town & Country/Caravan/Voyager

NOTE:

This bulletin applies to vehicles equipped with a 3.3L or 3.8L engine (sales code EGA, EGH or EGM) built on or before April 2, 2004.

SYMPTOM/CONDITION:

The vehicle operator may describe a rough idle after the engine has warmed up to normal operating temperature.

DIAGNOSIS:

Using a Scan Tool (DRBIII(R)) with the appropriate Diagnostic Procedures, verify all engine systems are functioning as designed. If DTCs are present
record them on the repair order and repair as necessary before proceeding further with this bulletin.

If the vehicle operator describes or experiences the Symptom/Condition, perform the Repair Procedure.

PARTS REQUIRED:

SPECIAL TOOLS/EQUIPMENT REQUIRED:

NOTE:

An updated J1962 cable has been released. This cable has a red colored connector at the DRBIII(R) connection. Use this cable whenever a flash is
being performed.

REPAIR PROCEDURE:

NOTE:

Whenever a controller is programmed, the software in the DRBIII(R), must be programmed with the latest revision level available.

Engine Controls - Warm Engine Rough Idle|Page 5024 > < Engine Controls/Ignition - MIL ON/Misfire DTC's Set|Page 5019