Grand Caravan V6-3.3L VIN R (2005)
Electronic Brake Control Module: Description and Operation
Antilock Brake Module (MK25E)
The Antilock Brake Module (ABM) is a microprocessor-based device which monitors the antilock brake system (ABS) during normal braking and
controls it when the vehicle is in an ABS stop or when in a traction control situation. The ABM utilizes a 47-way electrical connector on the vehicle
wiring harness. The power source for the ABM is through the ignition switch in the RUN or ON position.
Mk25e ICU
The ABM is mounted to the HCU as part of the Integrated Control Unit (ICU). The ICU is located in the engine compartment below the master cylinder
on the front suspension cradle/crossmember.
The primary functions of the Antilock Brake Module (ABM) are to:
-
Monitor the antilock brake system for proper operation.
-
Detect wheel locking or wheel slipping tendencies by monitoring the speed of all four wheels of the vehicle.
-
Control fluid modulation to the wheel brakes while the system is in an ABS mode.
-
Store diagnostic information.
-
Provide communication to the scan tool while in diagnostic mode.
-
Illuminate the amber ABS warning indicator lamp.
-
(With traction control only) Illuminate the TRAC ON lamp in the message center on the instrument panel when a traction control event occurs.
-
(with traction control only) Illuminate the TRAC OFF lamp when the amber ABS warning indicator lamp illuminates.
The ABM constantly monitors the antilock brake system for proper operation. If the ABM detects a fault, it will turn on the amber ABS warning
indicator lamp and disable the antilock braking system. The normal base braking system will remain operational.
NOTE: If the vehicle is equipped with traction control, the TRAC OFF lamp will illuminate anytime the amber ABS warning indicator lamp
illuminates.
The ABM continuously monitors the speed of each wheel through the signals generated by the wheel speed sensors to determine if any wheel is
beginning to lock. When a wheel locking tendency is detected, the ABM commands the ABM command coils to actuate. The coils then open and close
the valves in the HCU that modulate brake fluid pressure in some or all of the hydraulic circuits. The ABM continues to control pressure in individual
hydraulic circuits until a locking tendency is no longer present.
The ABM contains a self-diagnostic program that monitors the antilock brake system for system faults. When a fault is detected, the amber ABS warning
indicator lamp is turned on and the fault diagnostic trouble code (DTC) is then stored in a diagnostic program memory. A latched fault will disable
certain system functionality for the current ignition cycle. An unlatched fault will disable certain system functionality until the fault condition disappears.
These DTC's will remain in the ABM memory even after the ignition has been turned off. The DTC's can be read and cleared from the ABM memory by
a technician using a scan tool. If not cleared with a scan tool, the fault occurrence and DTC will be automatically cleared from the ABM memory after
the identical fault has not been seen during the next 3,500 miles. Drive-off may be required for the amber ABS warning indicator lamp to go out on the
next ignition cycle.
ABM INPUTS
