dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

System Description|Page 424 > < System Description|Page 422
Page 3
background image

must be properly centered when it is reinstalled on the steering column following any service procedure, or it could be damaged. The clockspring cannot
be repaired and it must be replaced.

PASSENGER AIRBAG

The front passenger airbag is equipped with dual stage squib inflators. When supplied with the proper electrical signal the inflator or inflators discharge
the gas directly into the cushion. The airbag module cannot be repaired, and must be replaced if deployed or in any way damaged.

WARNING:  THE PASSENGER AIRBAG MODULE CONTAINS INERT GAS PRESSURIZED TO 17236.89 kPa (2500 PSI). DO NOT
ATTEMPT TO IS MANTLE AN AIRBAG MODULE OR TAMPER WITH ITS INFLATOR.DO NOT PUNCTURE, INCINERATE, OR
BRING INTO CONTACT WITH ELECTRICITY. DO NOT STORE AT TEMPERATURE EXCEEDING 93° C (200° F). REPLACE
AIRBAG SYSTEM COMPONENTS ONLY WITH PARTS SPECIFIED IN THE MOPAR PARTS CATALOG. SUBSTITUTE PARTS MAY
APPEAR INTERCHANGEABLE, BUT INTERNAL DIFFERENCES MAY RESULT IN INFERIOR OCCUPANT PROTECTION. THE
FASTENERS, SCREWS, AND BOLTS ORIGINALLY USED FOR THE AIRBAG SYSTEM COMPONENTS HAVE SPECIAL COATINGS
AND ARE SPECIFICALLY DESIGNED FOR THE AIRBAG SYSTEM. THEY MUST NEVER BE REPLACED WITH ANY SUBSTITUTES.
ANY TIME A NEW FASTENER IS NEEDED, REPLACE IT WITH THE CORRECT FASTENERS PROVIDED IN THE SERVICE
PACKAGE OR SPECIFIED IN THE MOPAR PARTS CATALOG. FAILURE TO TAKE THE PROPER PRECAUTIONS CAN RESULT IN
ACCIDENTAL AIRBAG DEPLOYMENT AND PERSONAL INJURY OR DEATH.

AIRBAG SQUIB STATUS

1. Using a DRBIII(R) read Airbag DTC's If the following active codes are present:

If neither of the following codes is an active code:

ACTIVE DTC

SQUIB STATUS

Passenger squib 1 open
Passenger squib 2 open

Status of Airbag is Unknown.

CAUTION:  Deployed Front Air Bags may or may not have live pyrotechnic material within the air bag inflator. Do not dispose of Driver and
Passenger Airbags unless you are sure of complete deployment. Please refer to the Hazardous Substance Control System for Proper Disposal. Dispose of
deployed air bags in a manner consistent with state, provincial, local, and federal regulations. Use the following table to identify the status of the Airbag
Squib.

SEAT BELT TENSIONER (SBT)

The driver and passenger seat belt (buckle) tensioners are mounted to the inboard side of the front seats. The seat belt buckle and seat belt switch are
connected directly to the seat belt tensioner cable. At the onset of an impact event the ORC uses the seat belt tensioner to rapidly retract the seat belt
buckles. With the slack removed, the occupant's forward motion in an impact will be reduced as will the likelihood of contacting interior components.
The seat belt tensioner cannot be repaired, if damaged or defective it must be replaced. The ORC continuously monitors the resistance of the seat belt
tensioner circuits for open and shorted conditions.

SEAT BELT SWITCHES (SBS)

System Description|Page 424 > < System Description|Page 422