Grand Caravan V6-3.3L VIN R (2005)
1. If one or all Sensor/Transmitters cannot be trained, check for and avoid RF interference.
2. If one Sensor/Transmitter still cannot be trained, replace it and retry.
3. If all Sensor/Transmitters still fail to train, replace the SKREEM.
PRESSURE THRESHOLDS
The SKREEM will monitor the tire pressure signals from the Sensor/Transmitters and determine if any tire has gone below the low-pressure or above the
high-pressure thresholds. Refer to the tables below:
Low Tire Pressure Thresholds
High Tire Pressure Thresholds
*Tolerance ±6.9 kPa (1 PSI)
ACTIVE FAULT AND SYSTEM ALERTS
An active fault will be triggered when a system failure has been detected. When this occurs, the Instrument Cluster will illuminate the TPMS indicator
and the SKREEM will store the fault code. An alert will be triggered when a tire pressure has gone below or above the set threshold pressure. When this
occurs, the Instrument Cluster will flash the TPMS indicator. The SKREEM will request a secondary message to be displayed on the EVIC (if
equipped). Only when a tire pressure has gone below the set threshold pressure will the SKREEM request the TPMS indicator to flash and display the
EVIC message (if equipped). When a high pressure alert occurs, only the EVIC message will be displayed. This action will be displayed as long as the
alert condition is active.
Park Assist System
The Park Assist System display activates an audible tone that changes from intermittent to continuous as the final two Light Emitting Diodes (LED's) are
illuminated on one side or both sides of the display.
The system detection length from the rear of the vehicle is 0.3 meters to 1.5 meters. This area extends around the rear side of the vehicle.The system
detection height from the ground is 0.2 meters to about 1.5 meters. The radio mutes when the system activates its audible tone.
When the driver selects Reverse or Neutral the system scans for objects behind the vehicle using four sensors located in the rear bumper. Objects can be
detected from up to 1.5 meters. A warning display above the rear window provides both visible and audible warnings indicating the range of the
object.
The system is active only when the vehicle is in reverse or neutral for vehicle speeds less than 16 Km/h (10 mph). If the vehicles Parking/Emergency
Brake is applied, the system is deactivated.
The display contains two sets of yellow and red Light Emitting Diode's (LED's) that the driver can see in the rear view mirror. Each side of the vehicle
has its own warning LED's. The system provides a visual warning by illuminating one or more yellow LED's as the vehicle gets closer to the object. As
the vehicle continues to approaches the object, one red LED is illuminated and the system emits a series of short beeps. The tone will remain constant
and both red LED's are illuminated once the vehicle is within 12 inches (30.5 cm) of the object.
The system can be turned ON or OFF through the Electronic Vehicle Information Center (EVIC) when the vehicle is in PARK. If the park assist system
is
turned OFF, a single chime will sound and the EVIC will display the following message REAR PARK ASSIST OFF, when the vehicle is in reverse.
-
Ensure that the rear bumper is free of dirt and debris to keep the system operating properly.
-
Jackhammers, large trucks, and other vibrations could affect the performance of the system.
-
Ensure that the parking brake is not applied. If Service Park Assist System appears in the EVIC after making sure the rear bumper is clean,
