Grand Caravan V6-3.3L VIN R (2005)
Trunk / Liftgate Switch: Service and Repair
Exterior Handle Switch
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate and remove the liftgate trim panel.
3. Remove the rear lamp bar assembly from the vehicle.
4. Locate the two wires going to the exterior handle switch. Cut the tie strap and trace the wires to the large electrical connector and back the wires
out of the large connector and through the grommet. Take care to mark the location of the wire terminals in relation to the large connector so that
they are positioned in the appropriate cavities upon switch installation.
Rear Light Bar
5. Depress the two exterior handle switch retaining tabs and roll the switch out of the light bar assembly.
INSTALLATION
Rear Light Bar
1. Install the handle switch in the light bar assembly.
