dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Restraints - Air Bag Lamp ON/Impact Sensor DTC's Set|Page 1300 > < Restraints - Air Bag Lamp ON/Impact Sensor DTC's Set|Page 1298
Page 4
background image

NOTE:

The riv-nut procedure is applicable for vehicles built at the Windsor Assembly plant after May 24, 2004 or the St. Louis Assembly plant after June
28, 2004 or the Styler Assembly plant after June 28, 2004. Very few vehicles will require riv-nut replacement.

5.

If the vehicle equipped with fog lamps, disconnect electrical harness connectors from both fog lamps.

6.

Remove the 2 screws that secure the left and right wheelhouse splash shield to the front fascia.

7.

Carefully separate the lower air dam plastic push retainers from the lower radiator crossmember.

8.

Remove the right and left fascia upper bolts from the upper radiator crossmember. (Fig 2)

Restraints - Air Bag Lamp ON/Impact Sensor DTC's Set|Page 1300 > < Restraints - Air Bag Lamp ON/Impact Sensor DTC's Set|Page 1298