Grand Caravan V6-3.3L VIN R (2005)
b. Rotating Tool Tire Changers - Position the wheel on the changer so that the sensor valve stem is approximately 210° from the head of the
changer in a clockwise direction from the mounting end of the tool (Fig. 27) Make sure the sensor is clear of the lower bead breaker area to
avoid damaging the sensor when the breaker rises (Fig. 27). Rotate the tool in a counterclockwise direction to mount the tire. Use this
procedure on both the upper and lower tire beads.
6. Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (usually applied to driver's side B-pillar). Make
sure original style valve stem cap is securely installed to keep moisture out of sensor.
7. Install wheel and tire assembly on vehicle.
8. Drive vehicle for a minimum of five minutes while maintaining a continuous speed above 15 mph (24 km/h). During this time the system will
learn the new sensor ID code and will clear any DTCs automatically.
NOTE: If a sensor cannot be trained, refer to appropriate diagnostic information.