dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Battery Cable|Description and Operation|Page 6290 > < Battery Cable|Description and Operation|Page 6288
Page 3
background image

Test Ground Circuit Resistance - Typical

4. Connect the voltmeter to measure between the battery negative cable terminal clamp and a good clean ground on the engine block. Rotate and hold

the ignition switch in the Start position. Observe the voltmeter. If the reading is above 0.2 volt, clean and tighten the battery negative cable eyelet
terminal connection to the engine block. Repeat the test. If the reading is still above 0.2 volt, replace the inoperative battery negative cable.

Battery Cable|Description and Operation|Page 6290 > < Battery Cable|Description and Operation|Page 6288