Grand Caravan V6-3.3L VIN R (2005)
1.
Wipe the filler cap and area clean, then remove the cap.
2.
Fill the fluid reservoir to the proper level and let the fluid settle for at least two (2) minutes.
3.
Start the engine and let run for a few seconds, then turn the engine off.
4.
Add fluid if necessary. Repeat the above steps until the fluid level remains constant after running the engine.
5.
Raise the front wheels off the ground.
6.
Start the engine.
7.
Slowly turn the steering wheel right and left, lightly contacting the wheel stops.
8.
Add fluid if necessary.
9.
Lower the vehicle, then turn the steering wheel slowly from lock-to-lock.
10.
Stop the engine. Check the fluid level and refill as required.
11.
If the fluid is extremely foamy, allow the vehicle to stabilize a few minutes, then repeat the above procedure.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
