Grand Caravan V6-3.3L VIN R (2005)
7. Install the routing clamp with the bolt securing the power steering fluid hoses to the rear of the cradle crossmember (Fig. 11).
8. Using a crowfoot wrench on a torque wrench, tighten the power steering fluid hose tube nuts at the gear to a torque of 31 Nm (275 inch lbs.).
9. Install tie rod end into steering knuckle. Start tie rod end to steering knuckle attaching nut onto stud of tie rod end. While holding stud of tie rod
end stationary using a socket (Fig. 4), tighten tie rod end to steering knuckle attaching nut. Then using a crowfoot and socket (Fig. 13), tighten the
tie rod end attaching nut to a torque of 75 Nm (55 ft. lbs.).
10. If the vehicle is equipped with All-Wheel - install the power transfer unit.
CAUTION: Proper torque on the cradle reinforcement to suspension cradle mounting bolts is very important.
11. Install the reinforcement on the front suspension cradle crossmember and install the bolts attaching the reinforcement to the cradle crossmember
(Fig. 6). Tighten the M-14 size bolts to a torque of 163 Nm (120 ft. lbs.). Tighten the M-12 size bolts to a torque of 108 Nm (80 ft. lbs.).
12. Install the lower control arm rear bushing retainer bolts through reinforcement on each side of each lower control arm rear bushing. Tighten bolts
to a torque of 61 Nm (45 ft. lbs.).
13. Install the two bolts and bushings attaching the reinforcement and rear of cradle crossmember to body of vehicle (Fig. 6). Tighten bolts to a torque
