Grand Caravan V6-3.3L VIN R (2005)
Transmission Control System Relay: Description and Operation
41TE Automatic Transmission
41TE - Automatic Transmission
TRANSMISSION CONTROL RELAY - DESCRIPTION
The transmission control relay (Fig. 336) is located in the Intelligent Power Module (IPM), which is located on the left side of the engine compartment
between the battery and left fender.
OPERATION
The relay is supplied fused B+ voltage, energized by the TCM, and is used to supply power to the solenoid pack when the transmission is in normal
operating mode. When the relay is "off", no power is supplied to the solenoid pack and the transmission is in "limp-in" mode. After a controller reset
(ignition key turned to the "run" position or after cranking engine), the TCM energizes the relay.
Prior to this, the TCM verifies that the contacts are open by checking for no voltage at the switched battery terminals. After this is verified, the voltage at
the solenoid pack pressure switches is checked. After the relay is energized, the TCM monitors the terminals to verify that the voltage is greater than 3
volts.
