Grand Caravan V6-3.8L (2009)
Parking Assist Control Module: Service and Repair
Park Assist Module - Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the trim from the right quarter inner panel (2) to access the park assist module (1), which is located to the rear of the C-pillar and above
the right rear wheel housing. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Luggage Compartment Trim/Quarter
Trim Panel - Removal.
3. Disconnect the two body wire harness connectors (3) from the park assist module connector receptacles.
4. Remove the plastic push-in fastener (4) that secures the module to the right quarter inner panel.
5. Slide the module upward far enough to disengage the two lower mounting tabs from the stamped pockets in the right quarter inner panel.
6. Remove the module from the vehicle.
