Grand Caravan V6-3.8L (2009)
3.
Loosen 4 rear fascia retaining screws (Fig 1)
4.
Hold the fascia at the proper level to obtain proper fascia top edge mating lines at tail light and snug upper bolts only.
5.
Use a protected wooden or plastic handle to apply outward pressure in lower corners of fascia liftgate opening to reduce bow in top of fascia and
tighten lower screw on both sides with fascia in new position (Fig 2).
6.
Tighten the 4 screws to 5.5 N.m (49 in.lbs).
7.
Does top surface of fascia stay flat or have a gap between fascia and liftgate of 4 mm or greater?
a.
Yes >>> Proceed to Step # 9.
b.
No >>> Proceed to Step # 10.
8.
Replace and refinish rear fascia per manufacturers instructions. Refer to the detailed removal procedures available in DealerCONNECT >
TechCONNECT under: Service Info > 13 - Frame And Bumpers > Rear Fascia > Removal.
