Grand Caravan V6-3.8L (2009)
Body Emblem: Service and Repair
Nameplate - Installation
INSTALLATION
NAMEPLATES
1. Thoroughly clean all residue from the name plate or decal attachment areas of the body.
2. Wipe the attachment areas with a clean, lint-free cloth, moistened with a 50% solution of water and alcohol and then wipe dry the areas
immediately with a dry, lint-free cloth.
CAUTION: Do not exceed 52° C (120° F) when heating name plates, decals or body panels. Failure to follow this caution may result in damage
to the name plates, decals and/or the vehicle paint finish.
NOTE: If ambient temperatures are below 21° C (70° F), warm the name plate or decal and body panel with a heat lamp or gun to assure
proper adhesion.
3. Remove the protective covering from the back of name plate or decal and position the name plate or decal onto the body using the previously
installed guide tape.
NOTE: To ensure proper name plate or decal adhesion, apply consistent and uniform pressure of approximately 40 p.s.i. over the entire
surface of each name plate or decal.
4. Install the name plate or decal onto the body.