Grand Caravan V6-3.8L (2009)
Power Sliding Door Module: Service and Repair
Power Sliding Door Module - Installation
INSTALLATION
NOTE: Any time a power sliding door component is removed, replaced, door adjustment is performed or diagnostic trouble codes are
addressed and erased, a learn cycle must be performed. The power sliding door learn cycle enables the power sliding door control module
to learn or relearn critical information (travel limits, resistance to door travel, door position, etc.) which allows the system to perform properly
and safely.See: Doors, Hood and Trunk/Doors/Sliding Door/Testing and Inspection/Programming and Relearning for the appropriate
procedure.
1. Position the power sliding door control module onto the drive assembly (2) and install the retaining screws (1).
2. Connect the power sliding door control module (1) electrical connectors (3).
3. Install the power sliding door drive assembly, See: Doors, Hood and Trunk/Doors/Sliding Door/Power Sliding Door Drive Assembly/Service and
Repair/Power Sliding Door Drive Assembly - Installation.
4. Connect the battery negative cable.
5. Perform the power sliding door learn cycle, See: Doors, Hood and Trunk/Doors/Sliding Door/Testing and Inspection/Programming and
Relearning.
