Grand Caravan V6-3.8L (2009)
1. Position the seat cushion side shield (1) to the seat. If equipped with power seats, connect the wire harness connector to the power seat switch (5).
2. Engage the retaining tabs that secure the front of the seat cushion side shield to the seat by simultaneously sliding the side shield rearward and
down.
3. Engage the retaining tabs that secure the center of the seat cushion side shield to the seat by pushing the center of the shield straight into the side of
the seat.
4. Install the two screws (3) that secure the rear of the seat cushion side shield to the seat. Tighten the screws securely
5. Position the seat belt (2) to the seat and install the retaining bolt (4). Tighten the bolt to 48 Nm (35 ft. lbs.).
6. Install the seat belt (2) through the insert (3) and position the insert to the seat.
7. Engage the retaining tabs that secure the insert to the seat cushion side shield (1) by sliding the insert straight down. Make sure the retaining tabs
are fully engaged to the side shield.
8. If equipped with power seats, reconnect the negative battery cable.
INBOARD SIDE
1. Install the seat belt buckle (1) through the seat cushion side shield (2) and position the side shield to the seat.
2. Engage the retaining tabs that secure the front of the seat cushion side shield to the seat by simultaneously sliding the side shield rearward and
down.
3. Engage the retaining tabs that secure the center of the seat cushion side shield to the seat by pushing the center of the shield straight into the side of
the seat.
4. Install the two screws (3) that secure the rear of the seat cushion side shield to the seat. Tighten the screws securely.
Second Row, Swivel - Upper Swivel
INSTALLATION
NOTE: Right seat shown in illustrations. Left seat similar.
