Grand Caravan V6-3.8L (2009)
Seat Heater: Service and Repair
Heated Seat Contact - Installation
INSTALLATION
1. Position the 2nd row heated seat contact (1) into the vehicle.
2. Install the two retaining screws (2)
3. Secure the wire harness routing clip to the hole vehicle floor (3).
4. Connect the seat contact electrical connector (4).
5. CAUTION: The 2nd row floor trim ring may be damaged if excessively flexed or twisted. Take care to support the complete assembly
during removal and installation.
Install the 2nd row floor trim ring (2).
a. Position the trim ring (2) into the vehicle and align the holes with the weld studs on the vehicle floor.
b. Ensure the 4-way locator at the front and 2-way locator at the rear of the panel are positioned properly on the center seat tub reinforcement (1).
c. Install retaining nuts (3) starting with the center two front and rear nuts and working outward to both edges of the panel.
d. Install the retaining nut trim plugs (4).
6. Install the 2nd row seats.
7. Connect the battery negative cable.
