Grand Caravan V6-3.8L (2009)
11. Perform the Diagnostic Verification Test and clear any faults. See: Brake Bleeding/Service and Repair
Rear
INSTALLATION
1. Apply bearing grease (supplied with part) to sensor head shaft and O-ring.
CAUTION: Ensure that sensor mounting surface on bearing is clean before sensor installation.
2. Push wheel speed sensor head (1) into mounting hole in hub and bearing (3) and align mounting screw hole.
3. Install NEW mounting screw (2). Tighten mounting screw to 6 Nm (55 in. lbs.).
4. Install wheel speed sensor routing clip (2) into hole in rear axle.
5. Install wheel speed sensor (3) into routing clips (1) along brake flex hose.
