Grand Caravan V6-3.8L (2009)
Perform the following procedure on each rear brake caliper as necessary.
1. Raise and support vehicle. See: Maintenance/Vehicle Lifting/Service and Repair
2. Remove the wheel mounting nuts (3), then the tire and wheel assembly (1).
3. Remove the brake caliper lower guide pin bolt (1).
4. Swing the caliper assembly upward, pivoting off the upper guide pin, until clear of the adapter bracket.
5. Remove the outboard pad (5) from the adapter bracket.
6. Return the caliper back down over the adapter bracket into mounted position and install the lower guide pin bolt finger tight.
7. Slowly pump the brake pedal until the caliper fingers touch the outboard surface of the brake rotor. Release the pedal.
8. Remove the brake caliper lower guide pin bolt.
9. Swing the caliper assembly upward, pivoting off the upper guide pin, until clear of the adapter bracket.
10. Reinstall the outboard pad in the adapter bracket.
