Grand Caravan V6-3.8L (2009)
4. Install nuts (1) on dash mounted studs. Tighten nuts to 28 Nm (21 ft. lbs.).
5. Slide booster push rod (2) onto brake pedal pin (3). Install NEW retaining clip (1) securing push rod to brake pedal.
6. Route wiring harness over pedals assembly and install routing straps (1).
7. Connect wiring connector (2) at electronic throttle control (accelerator) (3).
CAUTION: Do not reuse the original stop lamp switch. Anytime a switch has been removed or its position compromised, a new switch must be
installed and adjusted. Do not attempt to readjust the switch.
