Grand Caravan V6-3.8L (2009)
4. Install the banjo bolt (3) connecting the brake flex hose (2) to the brake caliper (1). Be sure to install a NEW brake hose washer on each side of the
hose fitting as the banjo bolt is guided through the fitting. Thread the banjo bolt into the caliper and tighten it to 24 Nm (18 ft. lbs.).
5. If removed, install the caliper lever return spring (1) between the cable lever (2) and anchor bracket (3). Do not reconnect cable equalizer at this
time.
6. Access the interior of the vehicle, remove the brake pedal holder, then slowly pump the brake pedal until the rear caliper fingers touch the
outboard surface of the brake rotor where the brake pad was removed. Release the pedal.
7. Remove the brake caliper lower guide pin bolt.
8. Swing the caliper assembly upward, pivoting off the upper guide pin, until clear of the adapter bracket.
9. Reinstall the outboard pad in the adapter bracket.
10. Open the caliper bleeder screw at least one full turn.
