dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

Blend Door Actuator - Removal|Page 6098 > < Blend Door Actuator - Removal
Page 2
background image

1. Disconnect and isolate the negative battery cable.
2. If equipped, remove the silencer from underneath the passenger side of the instrument panel.
3. Reach up between the HVAC air inlet housing and the HVAC air distribution housing and remove the two screws (1) that secure the blend door

actuator (2) to the bracket located on the passenger side of the air distribution housing (3) and remove the actuator from the bracket.

4. Disengage the red locking tab and disconnect the wire harness (4) from the blend door actuator and remove the actuator from the vehicle.

Rear

REMOVAL

1. Disconnect and isolate the negative battery cable.
2. Remove rear heater-A/C housing (1) and place it on a workbench .
3. Disconnect the wire harness connector (2) from the rear blend door actuator (3).
4. Remove the two screws (4) that secure the rear blend door actuator to the back of the rear heater-A/C housing and remove the actuator.

Blend Door Actuator - Removal|Page 6098 > < Blend Door Actuator - Removal