Grand Caravan V6-3.8L (2009)
Blower Motor Resistor: Service and Repair
Removal - Front
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
WARNING: The blower motor resistor may get very hot during normal operation. If the blower motor was turned on prior to servicing the
blower motor resistor, wait five minutes to allow the blower motor resistors to cool before performing diagnosis or service. Failure
to take this precaution may result in injury.
NOTE: LHD model shown. RHD model similar.
1. Disconnect and isolate the negative battery cable.
2. If equipped, remove the silencer from below the passenger side of the instrument panel.
3. Disconnect the wire harness connector (2) from the blower motor resistor (3).
4. Remove the two screws (4) that secure the blower motor resistor to the front HVAC housing (1).
5. Disengage the retaining tabs (5) that secure the blower motor resistor to the HVAC housing and remove the resistor.
