dodge Workshop Repair Guides

Dodge Workshop Service and Repair Manuals

A/C Condenser - Removal|Page 6258 > < A/C Condenser - Description|Page 6255
Page 1
background image

Condenser HVAC: Service and Repair
A/C Condenser - Removal

REMOVAL

WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation See: Service

Precautions/Warning and See: Service Precautions/Caution. Failure to follow the warnings and cautions may result in serious or
fatal injury.

1. Disconnect and isolate the negative battery cable.
2. Recover the refrigerant from the refrigerant system See: Service and Repair/Refrigerant System Recovery. 
3. Remove the grille See: Body and Frame/Grille/Service and Repair/Grille - Removal.
4. Remove the nuts (3) that secure the A/C discharge line (1) and the A/C liquid line (4) to the condenser tapping block (2) located in the right front

corner of the engine compartment.

5. Disconnect the A/C discharge and liquid lines from the condenser tapping block and remove and discard the O-ring seals and gaskets.
6. Install plugs in, or tape over the opened refrigerant line fittings and condenser ports.
7. Remove the screw (5) that secures the condenser tapping block to the radiator (6).

8. Disconnect the transmission cooler lines from the transmission fluid cooler See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Fluid Line/Hose/Service and Repair/Procedures.

9. Install plugs in, or tape over the opened transmission fluid cooler ports.

10. Remove the upper radiator crossmember (2) and position it out of the way See: Body and Frame/Radiator Support/Service and Repair/Radiator

Crossmember - Removal

11. Disengage the retaining tabs (4) that secure the upper condenser mounting brackets (3) to the radiator.
12. Carefully push the radiator rearward for clearance.

NOTE: Be certain to note the location of each of the radiator and condenser air seals prior to removal of the A/C condenser. These air seals

must be properly installed for the A/C and engine cooling systems to perform as designed.

13. Lift the A/C condenser (5) straight upward to disengage the lower condenser mounting brackets from the radiator and remove the condenser from

the engine compartment.

A/C Condenser - Removal|Page 6258 > < A/C Condenser - Description|Page 6255