Grand Caravan V6-3.8L (2009)
NOTE: If the foam seal around the heater core is deformed or damaged, it must be replaced.
6. Carefully pull the heater core (1) out of the driver side of the air distribution housing (2).
7. Disconnect the HVAC wire harness (4) from the mode and blend door actuators (3).
8. Remove the three screws (1) that secure the top of the air distribution housing (2) to the rear of the HVAC housing (5).
NOTE: If the foam seal on top of the air distribution housing is deformed or damaged, it must be replaced.
9. Tilt the top of the air distribution housing rearward and disengage the two retaining tabs that secure the bottom of the air distribution housing to
the HVAC housing and remove the air distribution housing.
10. If required, remove the mode and blend door actuators from the air distribution housing.
Front Air Distribution Housing Installation
HOUSING-AIR DISTRIBUTION
WARNING: The heater core tubes are not serviced separately from the heater core. The heater core tubes should not be repositioned, loosened
or removed from the heater core. Failure to follow this warning may result in a coolant leak and possible serious or fatal injury.
NOTE: LHD model shown in illustrations. RHD model similar.
