Grand Caravan V6-3.8L (2009)
1. If required, install the mode and blend door actuators (3) onto the air distribution housing (2). Tighten the actuator retaining screws to 1.2 Nm (10
in. lbs.).
NOTE: If the foam seal on top of the air distribution housing is deformed or damaged, the seal must be replaced.
2. Position the air distribution housing to the rear of the HVAC housing (5) and engage the two retaining tabs that secure the bottom of the air
distribution housing to the HVAC housing.
3. Tilt the top of the air distribution housing upward and install the three screws (1) that secure the air distribution housing to the HVAC housing.
Tighten the screws to 1.2 Nm (10 in. lbs.).
4. Connect the HVAC wire harness (4) to the mode and blend door actuators.
NOTE: If the foam seal around the heater core are deformed or damaged, it must be replaced.
5. Carefully install the heater core (1) into the driver side of the air distribution housing (2).
