Grand Caravan V6-3.8L (2009)
Control Module HVAC: Service and Repair
Front Blower Motor Power Module - Removal
REMOVAL
WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or
service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to
discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions may result in accidental airbag deployment and possible serious or fatal injury.
WARNING: The heat sink for the blower motor power module may get very hot during normal operation. If the blower motor was turned on
prior to servicing the blower motor power module, wait five minutes to allow the heat sink to cool before performing diagnosis or
service. Failure to take this precaution may result in injury.
1. Disconnect and isolate the negative battery cable.
2. If equipped, remove the silencer from below the passenger side of the instrument panel.
3. Disconnect the two wire harness connectors (2) from the blower motor power module (5).
4. Remove the two screws (4) that secure the blower motor power module to the front HVAC housing (1).
5. Disengage the two retaining tabs (3) that secure the blower motor power module to the HVAC housing and remove the module.
