Grand Caravan V6-3.8L (2009)
Driver/Vehicle Information Display: Adjustments
Manual Compass Calibration
MANUAL COMPASS CALIBRATION
CAUTION: Do not place any external magnets, such as magnetic roof mount antennas, in the vicinity of the Remote Compass Module (RCM)
located under the instrument panel center stack hood. Do not place any electronic devices (cell phones, laptop computers, PDAs,
portable DVD players, etc), on or near the instrument panel as the RCM performance may be effected. Do not use magnetic tools
when servicing the RCM.
NOTE: Confirmation that the proper variance zone is programmed, is recommended whenever manual compass calibration is performed.See:
Compass/Adjustments for the appropriate procedure.
The electronic compass unit features a self-calibrating design, which simplifies the calibration procedure. This feature automatically updates the compass
calibration while the vehicle is being driven. This allows the compass unit to compensate for small changes in the residual magnetism that the vehicle
may acquire during normal use. If the compass readings appear to be erratic or the Electronic Vehicle Information Center (EVIC) displays "CAL",
perform the following manual calibration procedure. Also, any time EVIC service replacement components are installed, they must be calibrated using
this procedure. Do not attempt to calibrate the compass near large metal objects such as other vehicles, large buildings, or bridges; or, near overhead or
underground power lines.
NOTE: On vehicles equipped with an RER Navigational radio, manual compass calibration is not required, the compass is automatically
adjusted by the NAV system. See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Radio/Stereo/Description
and Operation/Radio - Description for more information.
Calibrate the compass manually as follows:
1. Turn the ignition switch to the ON/RUN position. Press and release the MENU push button (1) until "Personal Settings" is displayed.
2. Press the STEP push button (4) until "Calibrate Compass" is displayed.
3. Momentarily depress and release the RESET push button (3) to initiate the calibration procedure. The "CAL" symbol will come on solid in the
EVIC display.
4. Slowly drive the vehicle on a level surface, away from large metal objects and power lines, through one or two complete circles not exceeding 8
km/h (5 mph). The "CAL" message will disappear from the display to indicate successful compass calibration.
NOTE: If the compass display indicates an inaccurate compass heading or the display is locked up, the RCM may be inoperative and require
replacement.
NOTE: If the "CAL" message remains in the display, either there is excessive magnetism near the compass, or the EVIC is inoperative.
Attempt the calibration procedure at least one more time before performing EVIC diagnosis.
NOTE: If the wrong direction is still indicated in the compass display, the area selected for calibration may be too close to a strong magnetic
field. Repeat the manual calibration procedure in another location.
