Grand Caravan V6-3.8L (2009)
6. Due to the PCM/ECM / TCM programming procedure, a DTC may be set in other ECUs within the vehicle. Some DTCs may cause the MIL to
illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored DTCs" if there are any DTCs
shown on the list.
7. Do not allow the battery charger to time out or the charging rate to climb above 13.5 volts during the flash process.
8. The StarSCAN(R) and StarMOBILE(R) diagnostic tools fully support Internet connectivity and must be configured for your dealership's network.
For help on setting up your StarSCAN(R) / StarMOBILE(R) for the dealership's network, refer to the StarSCAN(R) / StarMOBILE(R) Quick Start
Networking Guide available on 'DealerCONNECT > Service > StarSCAN(R) and StarMOBILE(R) Tools > Online Documentation' under the
download center.
9. The operating software in the StarSCAN(R) and StarMOBILE(R) must be programmed with the latest software release level. The software level
is visible in the blue header at the top of the StarSCAN(R) and StarMOBILE(R) Desktop Client screens. For instructions on how to update your
scan tool, refer to the StarSCAN(R) / StarMOBILE(R) Software Update guide available on 'DealerCONNECT > Service > StarSCAN(R) and
StarMOBILE(R) Tools > Online Documentation' under the download center.
PARTS REQUIRED
Module/Programming Order Replacement Guide
MODULE/PROGRAMMING ORDER REPLACEMENT GUIDE
Match the module row with the condition that applies, after module replacement follow the chart down and program the modules in the chart order.
Module Programming
MODULE PROGRAMMING
The Wireless Ignition Node (WIN) controls the Vehicle Theft Security System (VTSS), Remote Keyless Entry (RKE). When a Powertrain Control
Module (PCM) is in need of replacement, perform the following steps in order:
NOTE: The PCM and the WIN should never be replaced at the same time. They should be replaced independently of each other.
1. If applicable, first replace the PCM with the original WIN still connected to the vehicle.
2. Using a scan tool program the new PCM. (This will ensure the transfer of the Secret Key data from the original WIN into the new PCM).
3. Replace the WIN, using the scan tool program the new WIN module. This will transfer the Secret Key data from the PCM into the new WIN.
4. With the scan tool reprogram the key FOBIK to the new WIN.
5. Ensure all the customer's keys have been programmed to the new module.
NOTE: If the original keys do not successfully program to the new WIN after the proper procedures are followed correctly, programming
new keys will be necessary.
PROGRAMMING THE SECRET KEY TO THE WIN
The secret key is an ID code that is unique to each WIN. This code is programmed and stored in the WIN, the PCM, and each ignition key transponder
