Grand Caravan V6-3.8L (2009)
Seat Belt Height Adjuster: Service and Repair
Seat Belt Turning Loop Adjuster - Removal
SECOND ROW - EXCEPT SWIVEL
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
1. Unsnap and discard the trim cover (4) from the height adjuster (2) on the upper C-pillar (5) to access the second row seat belt turning loop screw
(3). The trim cover is not intended for reuse.
2. Remove the screw that secures the turning loop to the height adjuster.
3. Remove the turning loop from the height adjuster.
4. Remove the upper trim (6) from the inside of the C-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/C-Pillar Trim Panel-Removal.
5. Remove the screw (1) that secure the top of the height adjuster to the C-pillar.
6. Disengage the tab at the bottom of the height adjuster from the keyed slot in the C-pillar.
7. Remove the height adjuster from the C-pillar.
