Grand Caravan V6-3.8L (2009)
Seat Belt Height Adjuster: Service and Repair
Front Seat Belt Turning Loop Adjuster - Installation
FRONT
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
1. Position the seat belt turning loop height adjuster (4) to the B-pillar (3).
2. Engage the tab at the bottom of the height adjuster into the keyed slot in the B-pillar.
3. Install and tighten the screw (2) that secures the height adjuster to the B-pillar. Tighten the screw to 39 Nm (29 ft. lbs.).
4. Reinstall the upper trim (1) onto the inside of the B-pillar. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Pillar
Trim/B-Pillar Trim Panel-Installation.
5. Position the seat belt turning loop onto the height adjuster on the upper B-pillar.
6. Install and tighten the screw (6) that secures the turning loop to the height adjuster. Tighten the screw to 39 Nm (29 ft. lbs.).
7. Snap a new trim cover (5) onto the height adjuster on the upper B-pillar.
