Grand Caravan V6-3.8L (2009)
12. Position the front seat belt (3) lower anchor to the bracket on the outboard side of the front seat cushion frame.
13. Install and tighten the screw (2) that secures the lower anchor to the bracket on the outboard side of the front seat cushion frame. Tighten the screw
to 39 Nm (29 ft. lbs.).
14. Install the seat belt (2) through the insert (3) and position the insert to the opening near the rear of the outboard seat side shield (1).
15. Engage the retaining tabs that secure the insert to the side shield by sliding the insert straight down. Be certain that the retaining tabs are fully
engaged with the side shield.
16. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed
following service of any SRS component. See: Service and Repair.
Second Row - Except Swivel
SECOND ROW - EXCEPT SWIVEL
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt
that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or
ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child
restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or
child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new
and unused replacement parts listed in the Chrysler Mopar(R) Parts Catalog.
