Grand Caravan V6-3.8L (2009)
7.
Using a heat gun, heat the shrink tube until glue comes out of both ends of the shrink tube (Figure 4).
CAUTION:
Do not point the heat gun at painted surfaces. Paint damage may occur.
8.
Using electrical tape, secure the sealed wire to the wiring harness (Figure 5).
9.
Secure the connector in its original position on the vehicle body panel.
10.
Snap the fascia into position.
11.
Install the three push pins located on the backside of the right rear wheel opening (Figure 1).
12.
Connect the negative battery cable.
