Grand Caravan V6-3.8L (2009)
NOTE: The flat sides (3) on the upper can flange must be positioned toward the sides of the crossmember/vehicle within 15 degrees to
maintain proper NVH levels.
2. Verify proper alignment of the bushing (2) in the crossmember (1) as shown.
3. Install the bushings (4) from the top down until they bottom out using press C-4212F (2) and installer D-163 (2) or equivalent.
REAR
NOTE: Front (1) and rear (2) bushings are not interchangeable, although they look similar. The rears have an extra step on the bottom of the
inner sleeve that inserts through the sheer bracket and the hole in the inner sleeve is smaller.
1. Place the rear bushing (2) into position on the front crossmember.
