Grand Caravan V6-3.8L (2009)
5. Install stabilizer bar link (2) mounting stud through rearmost hole in bracket on strut assembly (1).
CAUTION: When installing nut on mounting stud of stabilizer bar link, do not allow stud to rotate in it's socket. Hold stud from rotating by
placing an open-end wrench on flat surface machined into stud.
6. Hand thread nut (3) on end of stabilizer bar link stud. Place an open-end wrench on flat surface machined into link's mounting stud to hold stud
from turning while tightening nut. Tighten nut to 88 Nm (65 ft. lbs.).
NOTE: It is important to note that left and right side wheel speed sensor routing brackets (3) mount opposite one another on the strut making
it necessary to install the left side mounting screw from the rear and right side mounting screw from the front.
7. Attach wheel speed sensor routing bracket (3) to mounting flange (2) on strut assembly. Install and tighten screw (1) to 10 Nm (89 in. lbs.).
