Grand Caravan V6-3.8L (2009)
4. On each side of vehicle, remove nut (1) and thru-bolt (3) fastening axle trailing arm (2) to forward mounting bracket (4) on body.
5. Pull forward end of axle trailing arms (2) downward just enough for bushings to clear mounting brackets (1). It may be necessary to place a wood
block between arms and underbody to keep arms in this position.
6. Assemble special tools Remover 10106-3 (1) and Receiver 10106-4 (3) on Press C-4212F (4).
7. Place special tool assembly over bushing (2 and trailing arm (5) as shown. When properly installed, Press screw-drive will be toward outside of
vehicle. Note notch in Receiver 10106-4 (3) (not shown in figure) should be placed straight back toward rear axle once installed.
8. Tighten Press (4) screw-drive, pressing bushing (2) out of trailing arm (5) into Receiver.
9. Remove tools and bushing from trailing arm. Discard used bushing.
10. If opposite side trailing arm bushing needs to be removed, repeat 6 through 9 on opposite side bushing.
