Grand Caravan V6-3.8L VIN L (2007)
Trunk / Liftgate Latch: Service and Repair
Installation
Manual
INSTALLATION
1. Engage key cylinder link and place latch in position on vehicle.
2. Install screws attaching latch to liftgate. Tighten to 11 Nm (95 in. lbs.) torque.
3. Connect wire connector to liftgate latch.
4. Verify liftgate fit and operation. Adjust as necessary.
5. Install liftgate trim panel.
Power
INSTALLATION
1. Position the power latch in the vehicle.
2. Connect the liftgate lock cylinder link rod (Figure 1) on the cinch latch assembly. Rotate the plastic retaining clip 90° to lock retaining clip onto
the link rod.
Figure 1 POWER LATCH ORIENTATION
3. Connect the link rod on the lock cylinder.
4. Install three new power latch retaining bolts. Torque to 10 Nm (90 in.lbs.).
5. Connect the power latch electrical connector and secure push pin retainers.
6. Connect the battery negative cable.
