Grand Caravan V6-3.8L VIN L (2007)
4. Install seat belt turning loop onto height adjuster. Tighten all seat belt bolts to 39 Nm (29 ft. lbs.) torque.
5. Install quarter trim panel.
Figure 1 C-PILLAR
Removal
REMOVAL
1. Remove rear header trim cover.
2. Remove liftgate sill plate.
3. Remove second row seat belt turning loop on long wheel base vehicle.
4. Remove bolt attaching second row seat belt lower anchor to quarter on short wheel base vehicle.
5. Disengage hidden clips attaching trim to D-pillar.
6. Disconnect speaker wire connector, if equipped.
7. Pass seat belt through slot in D-pillar trim panel on short wheel base vehicle.
8. Remove D-pillar trim from vehicle.
Installation
INSTALLATION
1. Pass seat belt through slot in D-pillar trim panel on short wheel base vehicle.
2. Position D-pillar trim panel on vehicle.
3. Connect speaker wire connector to speaker, if equipped.
4. Align locating pins on backside of trim panel to mating holes in inner quarter panel.
5. Engage hidden clips attaching trim to D-pillar.
6. Install bolt attaching second row seat belt lower anchor to quarter on short wheel base vehicle. Tighten all seat belt bolts to 39 Nm (29 ft. lbs.).