Grand Caravan V6-3.8L VIN L (2007)
Door Lock Cylinder: Service and Repair
Removal
REMOVAL
1. Roll door glass up.
2. Remove front door watershield as necessary to gain access to the outside door handle. Refer to Front Door Panel.
3. Through access hole at rear of inner door panel, disconnect Vehicle Theft Security System (VTSS) switch connector from door harness, if
equipped.
4. Disengage push in fasteners attaching VTSS switch harness to inner door reinforcement bar, if equipped.
5. Disengage clip holding door latch linkage to door latch (Figure 1).
6. Remove latch linkage from latch.
7. Disengage clip holding door lock linkage to door latch.
8. Remove lock linkage from latch.
9. Remove nuts attaching outside door handle to door outer panel.
10. Remove outside door handle from vehicle.
11. Disengage clip holding lock cylinder into outside handle.
12. Pull lock cylinder from door handle.
Figure 1 OUTSIDE DOOR HANDLE