Grand Caravan V6-3.8L VIN L (2007)
Figure 12 FRONT SEAT BACK FOAM
10. Remove seat back cover from vehicle.
Installation
INSTALLATION
WARNING: To avoid personal injury or death, on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.
WARNING: To avoid personal injury or death on vehicles equipped with the occupant classification system (OCS), only the occupant
classification module (OCM) and the seat cushion trim may be serviced separately. All other components of the passenger side front seat
cushion assembly must be serviced only as a complete factory-calibrated, assembled and tamper-evident service replacement package. This
package includes the frame, springs, pad, bladder, sensor, foam, wiring and a calibrated OCM. When installing this package always replace all
of the existing components with the new components as a unit. Do not attempt to separate or disconnect any of the new OCS components in the
service replacement package from each other, and do not attempt to reuse any of the replaced components in this or any other vehicle. Failure
to take the proper precautions could result in failure of the passenger airbag to deploy when required, or in passenger airbag deployment when
not required.
NOTE: On Leather trimmed seats, the back cover can be removed from the back foam pad. On Cloth trimmed seats, the seat back cover does
not separate from the back foam pad.'
1. Place seat back cover on to the foam and push locking strip into the keepers to lock seat back cover into position (Figure 2) and (Figure 10).
2. Fit seat back cover and foam on to seat back frame (Figure 9).
3. Place seat back cover into position to clip J-straps (Figure 3) and (Figure 4).
4. Pull seat back cover tight, and attach the hook and loop strip (Figure 11).
5. Install seat back panel (Figure 8).
6. Install lumbar handle (Figure 7).
7. Install armrest cap and attaching bolt (Figure 6) and (Figure 5).
8. Install headrest sleeves and install headrest (Figure 1).
