Grand Caravan V6-3.8L VIN L (2007)
Figure 4 BLADDER MODULE HARNESS
8. Install bolts attaching seat cushion and OCS module attaching bracket to the seat track. Tighten seat bolts to 28.5 Nm (21ft. lbs.).
9. Velcro old seat cushion cover onto new foam.
10. Engage J-strap retainers to hold seat cushion cover to cushion.
11. Install seat track rear cover (if equipped).
12. Install seat cushion outer side covers.
13. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
14. Following successful completion of the supplemental restraint system verification test procedure, perform the Occupant Classification System
Verification Test using a diagnostic scan tool and the Occupant Classification Seat Weight special tool.
