Grand Caravan V6-3.8L VIN L (2007)
Power Seat Switch: Service and Repair
Removal
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a push pin remover or other suitable wide flat-bladed tool, gently pry the power seat and power recliner switch knobs off of the switch
levers(Figure 1).
Figure 1 REMOVING SWITCH CONTROL KNOBS - TYPICAL
3. Remove the screws that secure the outboard seat cushion side cover to the seat cushion frame.
4. Pull the outboard seat cushion side cover away from the seat cushion frame far enough to access the power seat switch wire harness connector.
5. Disconnect the power seat wire harness connector from the power seat switch connector receptacle.
6. Remove the screws that secure the power seat switch to the inside of the outboard seat cushion side cover.
7. Remove the power seat switch from the outboard seat cushion side cover.
