Grand Caravan V6-3.8L VIN L (2007)
2. Route the cable back toward the brake assembly placing it in the routing clip fastened to the underbody of the vehicle (Figure 2). Make sure to stay
to the inside of the left stabilizer bar link while routing either cable.
3. If the right rear cable is being serviced, install screws, attaching the cable routing clamps to the rear axle (Figure 1).
4. Pass the cable through the hole in the brake adapter and hook the cable eyelet to the shoe lever (Figure 4).
5. Install the screw fastening the cable to the rear brake adapter (Figure 4).
6. Pull straight back on the front cable button (and pliers) and properly attach the equalizer to all three parking brake cables (Figure 5).
7. Remove the locking pliers from the front parking brake cable and allow the automatic self-adjusting mechanism in the lever to take up any slack.
8. Lower the vehicle.
9. Apply and release park brake pedal 1 time. This will seat the parking brake cables.
Figure 1 Right Rear Cable Routing
Figure 2 Left Rear Cable Routing
