Grand Caravan V6-3.8L VIN L (2007)
Parking Brake Shoe: Service and Repair
Installation
INSTALLATION
1. Install park brake shoe actuator into adapter.
2. Install the trailing brake shoe on the adapter.
NOTE: When the hold down pin is installed, the long part of the hold down pin is to be positioned strait up and down. This will ensure
that the hold down pin is correctly engaged with the adapter.
3. Install the hold down spring and pin (Figure 14) on the trailing park brake shoe.
4. Install the upper return springs (Figure 11) on the trailing park brake shoe.
5. Install the upper return springs on the leading park brake shoe (Figure 15). Then position the top of the leading park brake shoe at the upper
anchor and rotate the bottom of the shoe outward until correctly installed on the adapter.
6. Install the adjuster (Figure 10) between the leading and trailing park brake shoe.
NOTE: When the hold down pin is installed, the long part of the hold down pin is to be positioned strait up and down. This will ensure
that the hold down pin is correctly engaged with the adapter.
7. Install the hold down spring and pin (Figure 16) on the leading park brake shoe.
8. Install the lower return spring (Figure 4) on the leading and trailing park brake shoes. When installing the return spring, it is to be installed
behind the park brake shoes (Figure 4).
9. Install the 4 mounting bolts for the adapter and hub/bearing into the bolt holes in the axle.
10. Position the adapter on the 4 mounting bolts installed in the rear axle (Figure 1).
Figure 1 Adapter Installed On Mounting Bolts (AWD Shown)
11. Install the hub/bearing on the stub shaft of outer C/V joint (AWD only) and into the end of the axle. (Figure 3).
12. In a progressive crisscross pattern, tighten the 4 hub/bearing mounting bolts until the hub/bearing is squarely seated against the axle. Then tighten
the hub/bearing mounting bolts to a torque of 129 Nm (95 ft. lbs.).
13. AWD only - Install the wheel speed sensor on the hub/bearing and adapter. Install the wheel speed sensor attaching bolt (Figure 2). Tighten the
wheel speed sensor attaching bolt to a torque of 12 Nm (105 in. lbs).
14. FWD only - Install the wheel speed sensor in the following fashion:
a. If metal wheel speed sensor retaining clip is not in the neutral installed position on hub and bearing cap, install from the bottom, if necessary,
and push clip upward until it snaps into position.
b. Install wheel speed sensor head into rear of hub and bearing aligning index tab with the notch in the top of the mounting hole. Push the sensor
in until it snaps into place on the metal retaining clip.
