Grand Caravan V6-3.8L VIN L (2007)
Figure 2 Retainers - Air Distribution Housing
Air Distribution Housing Installation - Front
AIR DISTRIBUTION HOUSING
NOTE: The air distribution housing must be removed from the HVAC housing and disassembled for service of the mode-air and blend-air doors.
1. Install the air distribution housing onto the rear of the HVAC housing by inserting the two tabs on the bottom of the distribution housing into the
slots located on the bottom of the HVAC housing and tipping the distribution housing forward until it is properly aligned with the HVAC housing.
2. Install the four screws that secure the air distribution housing to the HVAC housing. Tighten the screws to 2 Nm (17 in.lbs.).
3. Install the heater core.
4. Position the HVAC wire harness onto the air distribution housing.
5. Connect the HVAC wire harness connectors to the mode door actuator and the blend door actuator(s) located on the driver side of the air
distribution housing.
6. Install the HVAC housing.
Air Inlet Housing Removal - Front
AIR INLET HOUSING
WARNING: Refer to the applicable warnings and cautions for this system before performing the following operation. Failure to follow the
warnings and cautions could result in possible personal injury or death.
WARNING: On vehicles equipped with airbags, disable the airbag system before attempting any steering wheel, steering column, or
instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the
airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system.
Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.
NOTE: The air inlet housing must be removed from HVAC housing for service of the recirculation-air door.
NOTE: LHD model shown in illustrations. RHD model similar.
1. Remove the HVAC housing assembly.
