Grand Caravan V6-3.8L VIN L (2007)
18. If equipped, remove the nut that secures the A/C ground strap eyelet to the weld stud on the top of the right front strut tower (Figure 2) and remove
the strap from the stud.
19. Remove the bolt that secures the rear section of the A/C liquid line to the receiver/drier.
20. Disconnect the A/C liquid line from the receiver/drier and remove and discard the O-ring seal.
21. Install plugs in, or tape over the opened liquid line fitting and the receiver/drier outlet port.
22. Remove the nut that secures the A/C suction line and the A/C liquid line to the A/C expansion valve.
23. Disconnect the A/C suction line and the A/C liquid line from the A/C expansion valve and remove and discard the O-ring seals.
24. Install plugs in, or tape over the opened suction line and liquid line fittings and both expansion valve ports.
25. On RHD models, remove the rear section of the A/C liquid line from the retaining bracket located at the top of the dash panel
26. If the vehicle is equipped with the optional rear heating-A/C system, go to STEP 15. If the vehicle is not equipped with the optional rear
heating-A/C system, go to STEP 19.
27. Raise and support the vehicle.
28. Disconnect the A/C liquid front extension line from the underbody liquid line (Figure 3) and remove and discard the O-ring seal.
29. Install plugs in, or tape over the opened liquid line fittings.
30. Lower the vehicle.
31. Remove the rear section of the A/C liquid line from the engine compartment.
Figure 3 Underbody A/C Line Connections
Installation
INSTALLATION
FRONT SECTION
