Grand Caravan V6-3.8L VIN L (2007)
Figure 2 Underbody Line Connections
Installation
INSTALLATION
1. Position the A/C suction line into the engine compartment.
2. Remove the tape or plugs from the suction and liquid line fittings and expansion valve ports.
3. Lubricate new rubber O-ring seals with clean refrigerant oil and install them on the suction and liquid line fittings.
4. Connect the A/C suction and liquid lines to the front A/C expansion valve.
5. Install the nut that secures the A/C suction and liquid lines to the front A/C expansion valve. Tighten the nut to 23 Nm (17 ft.lbs.).
6. Engage the retainer that secures the suction line routing clip to the receiver/drier mounting bracket on the side of the right front strut tower in the
engine compartment.
7. Remove the tape or plugs from the compressor port and the suction line fitting.
8. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the suction line fitting.
9. Connect the A/C suction line to the A/C compressor.
10. Install the nut that secures the A/C suction line to the A/C compressor. Tighten the nut to 23 Nm (17 ft.lbs.).
11. Connect the drain tube to the wiper module drain on the right side of the engine compartment.
12. Install the air cleaner top cover and snorkel onto the air cleaner housing located on the right side of the engine compartment.
13. Raise and support the vehicle.
14. Remove the tape or plugs from the suction front extension line fitting and the underbody suction line.
15. Lubricate a new rubber O-ring seal with clean refrigerant oil and install it on the underbody suction line.
16. Connect the A/C suction front extension line to the underbody suction line. Tighten the fitting to 23 Nm (17 ft.lbs.).
