Grand Caravan V6-3.8L VIN L (2007)
Figure 4 Seat Sensor Against Wheel Interior
4. While holding sensor in position, tighten sensor nut to 6.5 Nm (58 in. lbs.) torque.
CAUTION: Over-torquing the sensor nut by as little as 12 Nm (106 in. lbs.) may result in sensor separation from the valve stem. Under
this condition, the sensor may still function, however, the condition should be corrected immediately.
5. Mount tire on wheel following tire changer manufacturers instructions, paying special attention to the following to avoid damaging tire pressure
sensor:
a. Rotating Wheel Tire Changers - Once the wheel is mounted to the changer, position the sensor valve stem approximately 210° from the head
of the changer in a clockwise direction before rotating the wheel (also in a clockwise direction) to mount the tire (Figure 5). Use this procedure
on both the upper and lower tire beads.
b. Rotating Tool Tire Changers - Position the wheel on the changer so that the sensor valve stem is approximately 210° from the head of the
changer in a clockwise direction from the mounting end of the tool (Figure 6) Make sure the sensor is clear of the lower bead breaker area to
avoid damaging the sensor when the breaker rises (Figure 6). Rotate the tool in a counterclockwise direction to mount the tire. Use this
procedure on both the upper and lower tire beads.
